Here's the channel breakdown as it stands now:
- 1: Beat repeat, EQ3 & auto filter
- 2: Dry
- 3: Saturator
- 4: Phaser
- 5: Grain delay
- 6: Dry
- 7: Auto filter
- Send A: filter delay, compressor
- Master: compressor
I've mapped 7 of the sliders on my X-Station to the channel volumes, and the buttons above to the mutes. The rest of the knobs and buttons control various effects parameters. Here's the template from the Novation X-Station editor so you can see what I mean:
Here's a run-down by section:
OSCS-MIXER
- SEND A: send A level (ch1)
- REPEAT: toggles beat repeat (ch1)
- LOW CUT: cuts the low on EQ3 (ch1)
- S. LEVEL: saturator dry/wet (ch3)
- S. BASE: saturator base level (ch3)
- P. LEVEL: phaser dry/wet (ch4)
- P. RATE: phaser rate (ch4)
- G.D LVL: grain delay wet/dry (ch 5)
The filters section is mapped to the auto filters on channels 1 & 7 (toggled via the 1-2 button). Ideally I'd have a separate controller for each filter, but this should do for
now.
- F. FREQ: filter frequency
- FLT. RES: filter resonance
- F.E. AMT: filter envelope amount
- F.L. AMT: filter LFO amount (filter 1 only)
- F. TYPE: filter type
- FLT. RTE: controls the filter rate for filter 1
- SEND A: feeds send A back to itself
- F.D. FRQ: filter delay filter frequency
More to come on this as it evolves :)
0 comments:
Post a Comment